We can, and we often do this for new Clients to identify risks at the design and operational stages and determine appropriate actions or inform the Client of potential risks.

We can perform certain continuous measurements. For example, noise, total gaseous organic carbon, combustion products. These parameters can be measured continuously for several days or longer.

Yes, we represent Clients in regulatory institutions and in legal disputes.

Yes, because specific requirements are established for sampling locations regarding how the sampling location must be equipped and/or samples taken. Failure to comply with these requirements may result in the measurements not being recognized.

It is possible, but the method detection limit is approximately 14 odor units, while the standard is 5 or 8 odor units.

This is not always the case, because if an EIA is conducted, the SAZ is established during the EIA procedures and a separate PVSV is not required.

First, the material components that enter and/or may enter the wastewater are identified, then it is determined which components, once in the wastewater, create or may create new substances (A+B=C), and additionally it is assessed what pollutants may be formed during the technological process (not directly from the substances used in the process, but due to ongoing processes).

The hazardousness of waste can be assessed theoretically or practically by conducting an acute toxicity test in the laboratory, based on the results of which the hazard property HP14 is determined without specifying a specific hazard.